XANSYS Message: 92756 [Go back to message list]
[bookmark on del.icio.us]
No rating yet
Rate item:

Subject: [Emag] electric-magnetic coupled simple circuit
Author: Grzegorz Sawczuk
Date: 2008-04-09 12:38:27

Hi Everybody,

I've the problem with coupling my electric-magnetic magnetizer jig model. Thus, I've done a simple model coupled coils (circuit coupled stranded coil - PLANE53 (plane element!!!) keyopt(1)=3 & CIRCU124 keyopt(1)=5) and while solution carries out, I'm watching bad warning - coefficient ratio exceeds.
I suspect this warning is connected with incorrect coupling my used elements.
I will be very grateful for help! Thank you in advance!

P.S.
I have analysed example VM207, but there is used axisymmetrical elements both coils and air, besides author taked advantage of symmetry model.
In my model I need use only plane elements and make not use of symmetry!


Regards,
Grzegorz Sawczuk
The Silesian University of Technology (SUT)
Gliwice, POLAND
Posts possibly associated with message #92756AuthorDateScore
92756[Emag] electric-magnetic coupled simple circuitGrzegorz Sawczuk2008/04/09 
92758Re: [Emag] electric-magnetic coupled simple circuitMike Yaksh2008/04/09 
92761Re: [Emag] electric-magnetic coupled simple circuitMike Yaksh2008/04/09 
92788Re: [Emag] electric-magnetic coupled simple circuitMike Yaksh2008/04/10