I have been tinkering around with the *moper,map command using it to MAP CFD
results onto my airfoil models, such as h and T values and pressures. I am
using v8.1, but started using the macro back in v6.0. In particular, I have
changed the kdim value from 3 to 0 (volume to surface per the help manual).
Interestingly, I basically get the same result using either 3 or 0.
Does anyone have any words of wisdom on this?
Regards,
J Page Strohl
Airfoil Structural Engineer
Power Systems Mfg., LLC
Web Site: http://www.powermfg.com
| Posts possibly associated with message #70338 | Author | Date | Score | |
|---|---|---|---|---|
| 26579 | MAP operation on *MOPER Command | John Swanson | 2001/07/31 | |
| 26627 | Re: MAP operation on *MOPER Command | Mike McNamee | 2001/08/01 | |
| 26687 | Re: MAP operation on *MOPER Command | John Swanson | 2001/08/02 | |
| 67014 | [GEN] *MOPER Command Question | Ricardo Moraes | 2004/02/19 | |
| 70338 | *Moper command | Page Strohl | 2004/06/16 | |
| 70344 | Re: *Moper command | Frank Exius | 2004/06/17 | |