XANSYS Message: 42813 [Go back to message list]
[bookmark on del.icio.us]
No rating yet
Rate item:

Subject: POST1-Strange behavior in contact pressure plot
Author: Kasilingam Arumugam
Date: 2002-10-17 10:10:00

Dear ANSYS experts,

My 2D model has 6 contact pairs. When I carry out postprocessing in the same
session after the solution, the contact pressures are plotted well. But If I
close the session and start again, one contact pair (it is one of the two
rigid-flexible contacts; there are four other flexible-flexible contacts in
the model) does not show up the contact pressure nor the contact status.
Also when I list using PRNS it says:

'No data available for the selected model or data location specifications'

This is weird! I use ANSYS 6.1. Has any of you noticed similar thing? I
used OUTRES,ALL,LAST during solution.

Any help will be greatly appreciated.

regards,
-Kasi

Kasilingam Arumugam

TCS @ Xerox Corporation
Rochester NY
585-265-5546
Posts possibly associated with message #42813AuthorDateScore
42813POST1-Strange behavior in contact pressure plotKasilingam Arumugam2002/10/17 
42854Re: POST1-Strange behavior in contact pressure plotKasilingam Arumugam2002/10/18 
42856Re: POST1-Strange behavior in contact pressure plotRandy Smith2002/10/18