XANSYS Message: 42798 [Go back to message list]
[bookmark on del.icio.us]
No rating yet
Subject: Re: [STRUC]Results
Author: Roberto Porto
Date: 2002-10-16 16:27:00You can play around with the contour plot limits and get a better idea of
what is hapening.
Regards,
Roberto Porto
DSC Engenharia
----- Original Message -----
To:
Sent: Wednesday, October 16, 2002 12:16 PM
> Carlos,
> Difficult to figure this sort of thing out over e-mail, but
> I'm avoiding working on our quality manual so I'll give it a
> try...
> If the elements are red, that means they have a high stress
> relative to the other model. Perhaps you have a very high
> concentrated compressive stress? That would show a contour
> near where the stress is and the rest would be red. What
> stress value are you plotting?
> Also, do the displacements make sense. The
> volumes could be flying apart or loads may not
> be transferred.
> Eric
> Eric Miller
> Director: Support,
> Training & Development
> Phoenix Analysis &
> Design Technologies
> (480) 813-4884, x103
> www.padtinc.com
> -----Original Message-----
> From: Carlos Franco [mailto:karlan@t...]
> Sent: Wednesday, October 16, 2002 8:03 AM
> To: xansys@yahoogroups.com
> Subject: [xansys] [STRUC]Results
> Hi:
> I have done a model with several volumes glued, when I apply the
> forces and i obtain the solution and i display the results all the
> volumes show their displacements but some of them don't display the
> stresses, instead of this the screen shows the elements in red.
> What is this? are the results so low that they can't be displayed? or
> are the restrictions bad applied?
> Thanks
> Carlos A. Franco
> Mechanical engineer
> Universidad Nacional de Colombia