XANSYS Message: 3846 [Go back to message list]
[bookmark on del.icio.us]
No rating yet
Rate item:

Subject: Re: Select and sf command
Author: Dave Lindeman
Date: 1999-08-09 12:33:00

Yassar:

Yes, but in your second sequence you also issued an ALLSEL command before
applying the pressures. This selected all of your elements, so ANSYS was able
to figure out what element faces were defined by your node set. If you had
left the ALLSEL out, you would not have gotten any pressure definitions - i.e.,
the use of a component did not change the behavior of the SF command, you got
your pressures simply because you now had elements selected.

Regards,

Dave

On Aug 9, 6:23pm, Yassar Ghanimi wrote:
> Subject: Re: [xansys] Select and sf command
> From: "Yassar Ghanimi"

> Dave

> Thank you for your response.
> The nodes were corectly selceted in the first command sequence. I
> just worte them to a component in the second sequence and applied the
> surface load.

> Regards

> Yassar Ghanimi
> Inst. for Materials Science, Welding and Forming
> Graz University of Technology

> Tel.: (0316) 873-7184
> Fax : (0316) 873-7187
> Kopernikusgasse 24
> A-8010 Graz/AUSTRIA

>-- End of excerpt from Yassar Ghanimi

Dave Lindeman 3M Center 235-1F-36 Tel: 651-733-6383
CAE Specialist St. Paul, MN 55144 Fax: 651-736-7615

Posts possibly associated with message #3846AuthorDateScore
3840Select and sf commandYassar Ghanimi1999/08/09 
3841Re: Select and sf commandDave Lindeman1999/08/09 
3844Re: Select and sf commandYassar Ghanimi1999/08/09 
3846Re: Select and sf commandDave Lindeman1999/08/09