XANSYS Message: 258 [Go back to message list]
[bookmark on del.icio.us]
No rating yet
Rate item:

Subject: Re: SELECT Criteria CORRECTION
Author: Peter Budgell
Date: 1999-01-15 13:17:00

Good point about the cylinder...

After running the commands in order to shorten the list of candidates:

ksln ! select keypoints at nodes
lslk,s,1 ! select lines fully defined by selected keypoints
asll,s,1 ! select areas fully defined by selected lines
vsla,s,1 ! select volumes fully defined by selected areas

selected areas and volumes could be checked one by one in a loop within
the macro for the presence of nodes (using NSLA,S,1 and NSLV,S,1) and
un-selected if they are not associated with nodes.

Peter C. Budgell pbudgell@o...
Senior Development Engineer 519-740-0757 ext.249
Innovative Steam Technologies FAX: 519-740-2051
200 Avenue Road http://www.otsg.com
Cambridge, Ontario, Canada N1R 8H5

> -----Original Message-----
> From: Weathers, Bob [SMTP:bweathers@t...]
> Sent: Friday, January 15, 1999 12:58 PM
> To: 'xansys@o...'
> Subject: [xansys] Re: SELECT Criteria CORRECTION

> From: "Weathers, Bob"

> very close

> will still have an occasional problem, though
> consider a hollow cylinder
> 4 keypoints
> 2 areas (one from 0 to 180 degrees & other from 180 to 360
> degrees)
> one area meshed and other one not

> macro (here we go again with macros!) will pick both areas

> [Peter Budgell]
> etc...


Posts possibly associated with message #258AuthorDateScore
251Re: SELECT Criteria CORRECTIONPeter Budgell1999/01/15 
252Re: SELECT Criteria CORRECTIONBob Weathers1999/01/15 
254Re: SELECT Criteria CORRECTIONTony Artiles1999/01/15 
258Re: SELECT Criteria CORRECTIONPeter Budgell1999/01/15 
259Re: SELECT Criteria CORRECTIONBob Weathers1999/01/15