XANSYS Message: 20647 [Go back to message list]
[bookmark on del.icio.us]
No rating yet
Rate item:

Subject: 2D Emag FEA of 2hp surface mounted pm motor
Author: nguyen_d_h@
Date: 2001-01-30 15:40:00

hi, all

i'm trying to a solve 2D Emag FEA problem of a 2hp surface mounted pm
motor. The modeling is a single pole modeling. After modeling the
geometry and meshing, it seem to work fine. I set parallel to lines
boundary condition to the opposite outside boundary and set the
PERBC2D on the symmetry boundary with odd-symmetry. The problem SOL
is fine. After viewing the 2D flux lines, it seems unrelistic.
the flux lines crosses the air gap and bend sharply to the side
(lelf) .. It should went straight through and curve to both side,
right. Can anybody tell me why it doing this ?

david

Posts possibly associated with message #20647AuthorDateScore
206472D Emag FEA of 2hp surface mounted pm motornguyen_d_h@2001/01/30 
20650Re: 2D Emag FEA of 2hp surface mounted pm motorBill Bulat2001/01/30