XANSYS Message: 184 [Go back to message list]
[bookmark on del.icio.us]
No rating yet
Rate item:

Subject: Re: Stress concentrations
Author: Evan Westermann
Date: 1999-01-12 08:21:00

Could I try to interject a little common sense into this problem.
Ignore the large stress. It is obvious that the sharp corner will
round over with repeated application of load and that the
large stress will go away. It you had seen a large area of high
stress in this region it might deserve the some attention, but from
what you describe it is highly localized and should not be of
concern

-----Original Message-----
To: undisclosed-recipients:;

>From: "Rick Fischer"

> I think there is a macro out there somewhere for selectivly
> removing midside nodes prior to contact application.

Posts possibly associated with message #184AuthorDateScore
168Stress concentrationsBrent Brower1999/01/11 
169Re: Stress concentrationsRick Fischer1999/01/11 
172Re: Stress concentrationsXiao Gong1999/01/11 
173Re: Stress concentrationsTom Davis1999/01/11 
174Re: Stress concentrationsPatrick Tibbits1999/01/11 
175Re: Stress concentrationsRick Fischer1999/01/11 
176Re: Stress concentrationsParis Altidis1999/01/11 
178Re: Stress concentrationsRick Fischer1999/01/11 
184Re: Stress concentrationsEvan Westermann1999/01/12 
186Re: Stress concentrationsRick Fischer1999/01/12 
187Re: Stress concentrationsBrent Brower1999/01/12 
188Re: Stress concentrationsRick Fischer1999/01/12 
49576[struct] Bolt Stress ConcentrationsCooper, Geoff geoff.cooper@2003/04/25 
49579Re: [struct] Bolt Stress ConcentrationsMarco Perucchi2003/04/25 
49581Re: [struct] Bolt Stress ConcentrationsMark Krueger2003/04/25 
49585Re: [struct] Bolt Stress ConcentrationsJohn Ceko2003/04/25 
49590Re: [struct] Bolt Stress ConcentrationsRonnie Thomas2003/04/25 
49591Re: [struct] Bolt Stress ConcentrationsChristopher Wright1969/12/31 
49592Re: [struct] Bolt Stress ConcentrationsIan Prentice2003/04/25 
49594Re: [struct] Bolt Stress ConcentrationsPhilippe Vidori2003/04/25